Mighty Mule MMKPD Installation Guide download pdf

Thank you for purchasing the Mighty Mule Digital MMKPD Keypad. Be sure to

read the directions carefully and completely. Before permanently mounting the

keypad, please program the keypad and test its range.

IMPORTANT: Your keypad must accept interference according to FCC

regulations listed below. For example, applications that are relativity close to

cell towers or airports may receive intermittent interference.

The Mighty Mule Digital Keypad is a multipurpose keypad that can work with

other applications in addition to Mighty Mule gate openers and locks. As a

wireless keypad it can be used with any gate or garage door opener and must

be used in conjunction with the GTO garage door receiver kit (part #RB709U-

NB).

SAFETY NOTE: Never install the keypad where a person can reach through

the gate to activate it, or where a person can touch the gate while activating

the keypad. The recommended minimum distance between the gate and

keypad is 10 ft.

25 Code Mighty Mule Digital Keypad

Instructions for the MMKPD keypad installation

FCC WARNING: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications.

However, there is no guarantee that interference will not occur in particular installations. If this equipment does cause harmful interference

to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures: • Reorient or replace the receiver antenna. • Increase the separation between

the equipment and the receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Keypad Features

Keypad

• The keypad illuminates and beeps at the press of any key.

• When a valid code is entered, the STATUS light will blink rapidly.

• The keypad remains active for 40 seconds after entering a valid code: pressing any key on the keypad while

the gate is in motion will stop the gate; pressing any key while the gate is stopped will cause the gate to

reverse direction. After 40 seconds, the keypad will beep 3 times and go into “idle” mode.

• If more than 20 key presses are entered without matching an Entry Code, the STATUS light will ash rapidly,

an error tone will sound for 1 second, and the keypad will go into “lock-down” mode for 40 seconds.

• If more than 10 seconds elapse between key presses, the keypad will beep 3 times and go into “idle” mode.

Master and Entry Codes

• Up to 25 Entry Codes may be programmed into the keypad.

• Temporary Entry Codes can be programmed to expire within one to seven (1–7) days.

• Entry Codes remain stored in memory even when the keypad batteries go dead.

• All Entry Codes are deleted by pressing the RESET button on the keypad; Master Code defaults to “1234.”

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - Keypad Features

Thank you for purchasing the Mighty Mule Digital MMKPD Keypad. Be sure to read the directions carefully and completely. Before permanently mounting th

Page 2 - Table of Contents

23Table of ContentsKeypad Features ... CoverKeypad De

Page 3 - 0 5

231 2 34 5 67 8091 2 34 5 67 809Keypad DescriptionInstalling BatteriesStep 1: Remove the two screws from the bottom of the keypad (FIG. 1) and separa

Page 4 - Program the Keypad

45Program New Master Code1. Press and Release Program Button:2. Enter current Master Code: (example: the factory default Master Code)3. Press and

Page 5 - Normal Keypad Operation:

45Normal Keypad Operation:• If the user enters a 4-digit code that is matched to one of the 25 stored codes. The STATUS light should blink rapidly ind

Page 6 - Limited One Year Warranty

67The contents of all material available on this installation manual are copyrighted by Gates That Open, LLC (“GTO”), unless otherwise indicated. All

Page 7

67Notes

Page 8

www.mightymule.com • 1800-453-GATE (4283)3121 Hartseld Road • Tallahassee, Florida, USA 32303 (850) 575-0176 • Fax (850) 575-8912

Comments to this Manuals

No comments

Mighty Mule MMKPD Installation Guide

Browse online or download Installation Guide for Numeric keypads Mighty Mule MMKPD. Mighty Mule MMKPD Installation Guide User Manual

Summary of Contents

Comments to this Manuals